Aluminium foil/strips:
EN AW-1080 / EN AW-Al 99,8

Material EN AW-1080 / EN AW-Al 99,8 according to DIN EN 573-3:2009-08
Article number
UWAL 2100
Product group
1080
Material
XX
Hardness
XXXX
Thickness
XXXXXX
Width
Material conditions H18 hard / H24 semi-hard / O soft (other hardnesses upon request)
according to DIN 485-2 or DIN 546-2 depending on strip thickness
Properties
H18 O
Tensile strength > 105 MPa 60 – 90 MPa
Yield strength 105 MPa 15 MPa
Elongation at break (depending on thickness) 1 % 20 – 26 %
Brinell hardness 45 HB 20 HB
Surface Front and back side: mill finished
Strip thicknesses Foil: 0.050 to 0.200 mm according to DIN 546
Strips: 0.200 to 15.000 mm according to DIN 485
Strip widths 10 – 1500 mm
Burrs unprocessed, burr-free, rolled, or rounded edge, edge radius, full radius
Inner diameter 150, 300, 400, 500 mm; depends on thickness; with and without sleeve
Outer diameter max. 2000 mm
Coil weights according to customer request; run lengths also available
Packaging up to 200 mm wide: vertical strip axis (eye to sky)
from 201 mm wide: horizontal strip axis (eye to wall)
on Euro / coil pallets or according to customer request

The data in this technical product information is based on our current knowledge and experience. Due to the abundance of possible influences during its application, it does not release the processor nor the user from performing their own tests and trials. A legally binding guarantee of certain properties or of suitability for a specific purpose cannot be derived from our information. Depending on the individual case, we recommend consulting with us. Any property rights and existing laws must be observed by the recipient of our products under their own responsibility.